Est. 2012  ·  Licensed & Insured  ·  MHIC #117311  ·  Owner-Operated
24/7 Emergency Service  ·  (855) 424-6217
📞 (855) 424-6217
Montgomery County · Maryland

Chimney Waterproofing in Martins Additions

When Martins Additions homeowners light the first fire of the season, they are trusting a flue nobody has looked inside since last winter. For Martins Additions homeowners, chimney Waterproofing runs on our regular Montgomery County route — Martins Additions is about 11 miles from our Beltsville headquarters — typically a 30-minute drive in normal traffic. The housing here — early-1900s colonials and cottages in a historic village enclave — shapes what our crews check first and what they carry on the truck.

Brick is a sponge. Masonry that soaks up rain and then freezes sheds its face a layer at a time — that is spalling, and it is the slow death of Maryland chimneys. Our vapor-permeable waterproofing stops liquid water at the surface while letting the wall dry from inside.

  • Licensed & Insured
  • Photo-Documented
  • ZIPs 20815
  • 24/7 Emergency
Chimney Waterproofing in Martins Additions, MD — Waterproofed brick chimney on a Maryland farmhouse
Chimney WaterproofingNow booking in Martins Additions · Montgomery County

About Chimney Waterproofing in Martins Additions

The critical word is vapor-permeable. Film-forming sealers and silicone coatings trap moisture inside the brick, and the wall destroys itself from within — we remove the damage those products cause every season. A proper chimney waterproofer is invisible, does not change the look of the masonry, and carries a 10-year manufacturer warranty when applied to sound, prepared brick.

What's Included

  • Vapor-permeable water repellent (no film, no sheen)
  • 10-year manufacturer warranty
  • Surface preparation and joint check included
  • Safe for historic and soft brick
  • Stops freeze-thaw spalling at the source

Martins Additions at a Glance

County: Montgomery County

State: Maryland

ZIPs served: 20815

Distance: about 11 miles from our Beltsville headquarters

Homes: early-1900s colonials and cottages in a historic village enclave

Response: 24/7 emergency · same-week appointments typical

Get a Free Estimate

Send the form and we will call to confirm a day and time — or skip the form and call (855) 424-6217 right now.

Please enter your name.
Please enter a valid US phone number.
That email does not look complete.
Please check the address.
Please enter a 5-digit ZIP.
Please pick a day that is not in the past.
Something went wrong sending your request. Please call (855) 424-6217 or use our booking form — we will take it from there.

No spam, no obligation. Your details go only to our scheduling team.

✓ Request received — thank you!We will call you shortly to confirm your appointment. If it is urgent, call us now at (855) 424-6217.
How It Works

Our Chimney Waterproofing Process in Martins Additions

1

Check the wall

Waterproofing goes on sound masonry — failed joints are pointed first.

2

Prepare

The chimney is cleaned and dried so the treatment bonds through the surface.

3

Apply

Flood coats are applied to refusal, crown to flashing.

4

Verify

Water behavior is checked and warranty paperwork handed over.

Local Chimney Notes

Why Martins Additions chimneys keep us busy: Tall stacks, tricky draft

Two-storey stacks and exposed rooflines around Martins Additions make draft a local science: wind over the ridge, a flue that ends below the highest roof point, or a house sealed tight by new windows can all push smoke back into the room. We measure the stack against the 3-2-10 rule, check the damper and smoke shelf, and fix the geometry or the cap — not with guesses, but with the cause identified on camera. Homeowners see the same footage we do, on the spot, before any quote is written.

We are a chimney-only company — sweeps, scans, masonry and liners are the whole business, and it shows in the questions we ask and the photos we bring back down the ladder.

FAQ

Chimney Waterproofing Questions in Martins Additions

Does waterproofing fix an active leak?
It fixes absorption leaks through porous brick. Open joints, crowns and flashing are repaired first — waterproofing is the finish, not the patch.
Why not just use a hardware-store sealer?
Most are film-formers that trap vapor inside the wall. The brick then spalls from the inside out — a far more expensive repair than the leak you started with.
How fast can a crew reach Martins Additions for chimney Waterproofing?
Martins Additions is about 11 miles from our Beltsville headquarters — typically a 30-minute drive in normal traffic. Regular appointments are batched into Montgomery County route days several times a week, and emergency calls — chimney fires, smoke in the home, carbon-monoxide alarms — are dispatched 24/7 at (855) 424-6217.
How long does a sweep visit take?
A standard sweep with inspection at a Martins Additions home runs about 45 to 75 minutes once we are set up. Level 2 camera scans, multiple flues or repair quotes add time. We lay drop cloths, seal the firebox opening and HEPA-vacuum as we go — the room is left as clean as we found it.

Chimney Waterproofing in Nearby Communities

Route days in Martins Additions rarely end at the town line: the same truck usually continues to Somerset (ZIP 20815), Friendship Heights and Chevy Chase before heading back to Beltsville — so chimney Waterproofing in Martins Additions batches with the rest of the Montgomery County run, and same-week appointments stay possible here even in October.

More Chimney Services in Martins Additions

See the full chimney service in Martins Additions page for this community's own notes, seasons and reviews.

Chimney Waterproofing in Martins Additions — Booked in One Call

Photo-documented work and upfront written estimates, about 11 miles from our Beltsville headquarters. Talk to a chimney specialist today.